How to Clean & Freshen the Toilet

Scrubby Tout
“The power of foaming bleach and a scent you’ll love. Bubbly Bleach Gel is cleaning reinvented!”

-Scrubby

Scrubby likes to say a clean toilet is as easy as one-two... See, how’s that for easy? There isn’t even a three. So, let’s get started!

First step: Get it clean. For that, there’s nothing better than Scrubbing Bubbles® Bubbly Bleach Gel Toilet Bowl Cleaner. Don’t let the fresh scent fool ya! This powerful bleach foam cleans like no other. Even has an extended-reach neck to get those hard-to-reach spots – like under the rim – for full toilet bowl freshness! Getting it clean, however, is only half the story.

Second step: Keep it fresh. (Spoiler alert!) This step is even easier that the first one. With Scrubbing Bubbles® Fresh Gel you barely need to do anything. Simply use the dispenser to stamp a gel disc under the rim – no touching necessary – and you’re done! Your toilet gets freshness with every flush.

Get it clean. Keep it fresh. Scrubby calls it the one-two punch for a tidy toilet!

How-To Steps

GET IT CLEAN

  1.  Lift the toilet seat. 

  2.  To remove the cap, squeeze the two textured side surfaces and unscrew completely. 

  3.  Tip the bottle to fill the neck. 

  4.  Direct liquid under the rim and squeeze evenly around the bowl. 

  5.  Brush above and below the waterline and flush. 

  6.  Replace cap and close tightly until an audible click is heard. 

For stubborn stains, allow Scrubbing Bubbles® Bubbly Bleach Gel Toilet Bowl Cleaner to sit for several minutes.

 

KEEP IT FRESH

Apply Scrubbing Bubbles® Fresh Gel Toilet Cleaning Stamp to a clean toilet.

  1.  SNAP: Slide the two pieces together so that the button on the GEL TUBE snaps into the first hole on the blue HANDLE.  

  2.  PLACE: Remove cap and position end of GEL TUBE near the rim on inside of bowl.  

  3.  PUSH: Press and hold button down while pushing unit towards the bowl.  When button clicks into the next hole, pull unit back to leave a gel stamp. 

  4.  CAP: Replace cap securely and store.  

  5.  REFILL: After dispensing the last gel stamp, remove GEL TUBE from APPLICATOR. Keep APPLICATOR for refill.

Retain outer packaging for full use and safety instructions.

You might also like